2004-07 dodge durango1. using a small hook tool remove the screw cover from the door release handle...
TRANSCRIPT
+12v Constant = Gray/Red +12v Acc. Switch = -12v Chassis Ground= Black/Green +12v Illumination = +12v Dimmer = Amp Remote = Can-Bus = White/Orange(+)/White(-)
LF+ = Lt. BlueLF- = Lt. Blue/Black
RF+ = Gray RF- = Gray/Black LR+ = Lt. Green/Blue LR- = Green/Orange RR+ = Gray/Blue RR- = Gray/Orange
Dash Type: Din and 1/2Aftermarket Type: Single/DoubleKit: CR1286B/CR1289BHarness: CR03SRAntenna Adapter: CRAB/CRARB
Interface Adapter(s):CAN-Bus protocal. (TBA)
About the Vehicle
Make: DodgeModel: DurangoYear: 2004-07
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Rear
Dodge Durango
NOTES
Dimensions:
Dimensions: W= 5-5/8'' L= 5-5/8'' D= 7''
NOTES
Rear Doors: 6.5'' MidrangeSpeaker Adapter: SAC656/SAU56Speaker Harness: TBA
Standard/OptionalCD PlayerIn-Dash 6 Disc ChangerMP3 CompatibleAux-InputSirius RadioInfinity System ( 9 Speaker System)Navigation
W= 5-5/8'' L= 5-5/8'' D= 3-2/8''
Type: Standard Audio System Location: At Speakers
Front Dash : 3.25'' FullrangeLower Door: 6 1/2” MidbassSpeaker Adapter: SAC656/SAU56Speaker Harness: TBA
Speaker Sizes
When installing aftermarket 5 ¼" or 6 ½" a speaker adapter is needed.
When installing aftermarket 5 ¼" or 6 ½" a speaker adapter is needed.
2004-07
Dodge Durango
Images
Front Speakers
Rear Speakers
Radio removal
Front Speakers
Rear Speakers
1. Using a small hook tool remove (2) screw coversfrom the passenger side "A" pillar handle. Extract(1) 10mm bolt from behind each screw cover.Remove passenger "A" pillar.2. Using a PRT remove drivers side "A" pillar.3. Using a PRT remove entire top dash panel covering dash speakers.4. Extract (2) PHS securing the speaker to the dash.
1. Extract (2) 9/32" PHB from underneath the frontdash bezel surrounding the radio and housing the HVAC controls.The bolts are located in the cubbyhole in front of the center console. Disconnect and remove entire radio bezel.2. Extract (4) 9/32" PHB securing the radio to the dash. Disconnect and remove.
Radio
Dash Fullrange
Recommended: Disconnect negative battery cable
"A" Pillar Tweeter
Door Speakers1. Using a small hook tool remove the screw coverfrom the door release handle trim panel. Extract (1) PHS from underneath screw cover.2. Extract (2) 9/32" PHB from the bottom lip of the door panel.3. Lift entire door panel up to release door panel hooks. Remove door panel. Disconnect and remove.4. Extract (3) PHS securing speaker adapter to doorsteel. Disconnect and remove.
Door Speakers1. Using a small hook tool remove the screw coverfrom the door release handle trim panel. Extract (1) PHS from underneath screw cover.2. Extract (2) 9/32" PHB from the bottom lip of the door panel.3. Lift entire door panel up to release door panel hooks. Remove door panel. Disconnect and remove.4. Extract (3) PHS securing speaker adapter to doorsteel. Disconnect and remove.
2004-07