1 elct class performance (quizzes 1&2 and midterm)
TRANSCRIPT
![Page 1: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/1.jpg)
1
ELCT Class performance (Quizzes 1&2 and Midterm)
![Page 2: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/2.jpg)
2
Full wave rectifier circuits
1. In a full wave rectifier circuit, usually a transformer is used to isolate the load from the ac power line, and provide out of phase input voltages.
2. It also allows the designer to choose the input to the rectifier circuit from the turns ratio.
![Page 3: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/3.jpg)
3
Diode-bridge full-wave rectifier
Note that the capacitor is half compared to a half-wave rectifier circuit, as the capacitor needs to discharge for only half the time.
The output voltage can be further “smoothed out” by using a regulator circuit.
![Page 4: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/4.jpg)
4
Voltage Regulator Circuits
![Page 5: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/5.jpg)
5
A Simple Zener-Diode Voltage Regulator
![Page 6: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/6.jpg)
6
Calculate the source regulation for a Zener diode with characteristics shown below.
Example on source regulation
In general:
Slope of the load line is -1/R. Thus, change in supply voltage changes the position of the load line, but not the slope
![Page 7: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/7.jpg)
7
Load-Line Analysis of Complex Circuits
![Page 8: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/8.jpg)
8
Found by considering open circuit in place of the diode in part (b)
Found by considering open circuit in place of the diode and assuming the source to be short circuit
From the Thevenin equivalent circuit, we can write the load equation as:
Example: Analysis of a Zener-diode regulator with load
![Page 9: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/9.jpg)
9
Solution continued
![Page 10: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/10.jpg)
10
Found by considering open circuit in place of the diode in part (b)
Found by considering open circuit in place of the diode and assuming the source to be short circuit
From the Thevenin equivalent circuit, we can write the load equation as:
Example: Analysis of a Zener-diode regulator with load
![Page 11: 1 ELCT Class performance (Quizzes 1&2 and Midterm)](https://reader035.vdocuments.us/reader035/viewer/2022062315/5697c01e1a28abf838cd1508/html5/thumbnails/11.jpg)
11
Solution continued
Thus, the solution is : Vd = -10 V, and id = -10 mA