1 children’s safety. 2 safety requirements for baby’s and children’s wear ** blue island (bd)...
TRANSCRIPT
2
S afety Requirements for ’Baby s and ’Children s Wear
**Blue Island (BD) Ltd requirements and restrictions and suppliers responsibility
**Needles and sharp objects
**Decorations and small parts
**Drawstrings and cords
**Buttons
**Zippers
3
( ) Blue Island BD Ltd requirements and restrictions and suppliers responsibility**Needle detector, Safe Q machine, testing methods…
4
Needles and sharp objects
**Although has implemented strict routines to be followed, below sharp objects has been found in all supply products…
**…Some of our youngest customers has been seriously wounded!
5
Decorations and small parts
**Bows and other decorations….
* Must be firmly stitched, not only glued.
* Must not have sharp edges.
* Must always be attached with woven reinforcement on the back of the fabric.
* Must be adequately finished to secure the ends, a knot is not allowed.
6
Decorations and small parts
**Sequins, beads and pearls and glued on decoration…* Can not be tested in 90/50N pull force.
* Must be checked for sharp edges and point’s.
* Need to be washed tested 5 times to ensure that decorations are intact after wash.
7
Decorations and small parts
**Motives and labels…* Must be firmly stitches, not only glued.
* Must withstand 90 N pull force if fitting entirely testing cylinder and is not stitched all way around.
* Must not break or have sharp edges.
*Flags labels that are made of flat woven tape with no sharp edges or labels that are stitched all way around does not have to be tested in 90N.
8
Drawstring and cords
**Hoods on outerwear must be detachable.
**Ends of drawstring must be secured.
Not okOk
9
Drawstring and cords
**Toggles or other embellishment shall only be used of drawstring with no free ends.
**When using a loop drawstring the overlapping of the endings must be at least 3 cm.
**Belt loops shall be designed to lie flat against the garment with maximum length of 7,5 cm(as per Buyer standard).
10
Buttons
**All sewn on buttons…* Must be securely fastened with lock stitch.
* Must withstand the 90N pull force for 10 seconds if the button dimension is greater than 6mm.
* Withstand the 50N pull force for 10 seconds if the button dimension is less or equal to 6mm.
* Must not break or have sharp edges.
* Shall have 2-hole button rather than 4-hole button (as per Buyer standard) .
11
Buttons
**Press- and Jeans buttons, rivets and eyelets…* Must withstand the 90N pull force for 10 seconds if the button dimension is greater than 6mm.
* Must withstand the 50N pull force for 10 seconds if the button dimension is less or equal to 6mm.
* Must not break or have sharp points and edges.
* Upper and lower parts must have a perfect matching when closed.
12
Zippers
**All zippers must meet the Buyer’s requirements.* All parts of the zipper must not break or have sharp edges.
* All garments with a metal zipper must have a zipper guard facing the body to prevent injury.
* Styles with a zip fly must have a zipper guard firmly secured at the bottom. This is valid for all types of zippers in metal, plastic and nylon.
Zipper guard
13
Puller attachments
**Puller attachments with play value that are shaped, filled or made of any other material than a plain woven tape must also fulfill the “resistance to twist of pull and slider”.
**Pullers with play value:
14
Puller attachments
**Pullers with no play value must withstand 90N pull test but no need to test “resistance to twist of pull and slider”.
**Ensure a zipper does have a “fold over”.
Not ok Fold overStitched together.
Max. total length 7,5 cm